Furman M-8S Merit Series 9-Outlet Power Conditioner with Sequencer

15 Amp Standard Power Conditioner with Sequencer

Install an M-8S in your rack, and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-amp load.

Merit M-8S Power Sequencer is the perfect low-cost AC power solution for any rack mount system where power sequencing is desired.

Install an M-8s in to the top slot of your rack, and the six delayed outlets in the rear panel will power up sequentially and protect all your equipment up to a 15-amp load.

Includes 3 delayed outlet banks - each with 2 outlets - plus 2 unswitched outlets.

Features:

• Power Sequencing
• Prevents excessive inrush currents.
• Six sequenced rear panel outlets (in three groups), two unswitched rear panel outlets, and one front panel unswitched outlet.
• Momentary and maintained sequencing via rear panel terminal block or front panel switch (momentary only).
• Noise Filtration
• Noise filtering to reduce radio frequency and electromagnetic interference.
• Surge Protection
• Ensures equipment stays safe.
• 9 Total Outlets
• Eight rear panel outlets and one front panel convenience panel outlet.
• 15 Amp Rating
• 15 amp rating, with circuit breaker.
• "Protection OK" Indicator
• Front panel indicator LEDs for Outlet Banks, Protection OK and Power Status.
• Wall Wart Spacing
• Rear outlets have been spaced to accommodate even the bulkiest of wall warts and adapters.
• All settings and configurations available on rear panel.

Specifications:

• Maximum Output Current: 15 amps, 120 VAC (thermal breaker)
• Line Cord: 14 AWGx3, 10 feet, black, fixed, NEMA 5-15P plug
• AC Receptacles:
  Convenience Outlet (Front Panel): 1 un-switched NEMA 15-5R
  Rear Panel Outlets: 2 un-switched NEMA 5-15R (1 duplex)
  6 Sequenced Outlets: NEMA 5-15R (3 duplexes, each controlled by separate relay)
• AC Surge Protection: Merit class (sacrificial)
• Protection Modes: Line to neutral, zero ground leakage (spike protection)
• Operating Voltage: 130 V RMS (max continuous)
• Max Clamp Voltage: 500 V peak
• Peak Impulse Current: 12,000 amps
• Energy Rating: 225 joules
• Filtering: Standard level Pi LCR filter (AC)
• Noise Attenuation: > 26 dB, 100 kHz to 1 MHz
• Operating Temperature Range: 5 C (40 F) to 40º C (105º F)
• Humidity Range: < 90% rH (relative humidity)
• Switch: Front panel, sequence (ON, OFF)
• Circuit Breaker: Front panel, push to reset (thermal)
• Front Panel Indicators: Delay 1, delay 2, delay 3, power, protection OK
• Dip Switches: 12V Mode on/off, GND mode on, momentary/maintained (rear panel)
• Potentiometer: Rear panel, time calibration fine tune delay adjust
• Remote Terminal: +5-30 VDC In, 12 VDC (12 mA) out
• Phoenix type 4-pin connector with screw terminals; +12V, STAT, REM, GND (class 2 wiring)
• Dimensions: 19.00 x 8.75 x 1.75" (482.60 x 222.30 x 44.50 mm)
• Weight: 7.00 lb (3.18 kg)

Includes:

• Furman Merit M-8S Power Sequencer
• Limited 3-Year Warranty